The Network Controller LX-SEC-V1000 is the TCP/IP interface for
server connectivity and access control processing for up to 32
interface panels. The LX-SEC-V1000 boasts a 32-bit RISC processor
running the Linux Operating System. On-board flash memory
allows program updates to be downloaded via the network. The LX
SEC-V1000 connects up to 32 Door/Reader, Input Monitor, or
Output Control Interface Panels via two independent RS-485
networks, each network having two sets of input connections for
optimum system topology. This architecture minimizes the impact
on corporate LANs by using only one TCP/IP address for every 32
interfaces, and by handling low-level transactions on the RS-485
network.
Easily Interfaced
RJ-45 connector for Ethernet TCP/IP
Quick-disconnect screw terminal connectors:
- Four RS-485 connections to interfaces
- 2 supervised analog inputs for general purpose applications
- 2 non-latching output relays for local alarm annunciation (rated 2A
@ 30 VDC)
- DC Power input
- Tamper input*
- AC Power Fail input*
- Battery Fail input*
* Can be configured as a general purpose input
Local Processing
The access control system interfaces with combinations of devices with a
maximum of:
- 32 Door/Reader Interface Panels (up to 64 doors/readers) or
- 32 Input Monitor Interface Panels 9 (up to 512 monitor points)or
- 32 Output Control Interface Panels (up to 384 control relays)
Technical Data Dimensions: 147.32 mm x 122.55 mm x 32.38 mm
Enclosure Material: UL94 Polycarbonate
Operating Environment: Temperature 0°to 50°C, Humidity 5% to 95% relative (non-condensing)
Mounting: Mount to any wall surface, using four screws. The unit should be installed indoors, inside a
secure area, such as in an IT or telecommunications room, utility closet or on a wall above a
suspended ceiling. For UL compliance, one or more interfaces can be mounted inside a NEMA
4 rated enclosure.
Power Supply Requirements: 140 mA @ 12-18 VDC
Recommended: Supervised linear power supply with battery backup, input surge protection,
and supply fail and battery low contact outputs. Separate supervised DC supplies with battery
back-up recommended for relay activated devices.
Communications Ports: RS-485 – two wire, TCP-IP-one port (10 or 100 Mbps)
Visual Indicators: Power LED indicates that sufficient DC voltage is being provided to the unit. RS
Communications LED: solid green indicates successful communications to downstream
devices, red flash indicates a failed communications attempt, solid red indicates no
communications.
Processor: 32-bit RISC CPU, 100 MHz
Memory:
• 8 MB onboard Flash memory
• 16 MB / 32 MB memory expansions available
• 32 MB SDRAM
• 256k SRAM
Certifications: UL 294 and UL 1076 Recognized Component for the US, CSA 205 for Canada
FCC Class A Verification
EMC for Canada, EU (CE Mark), Australia (C-Tick Mark), New Zealand, Japan EN 50130-4 Access Control Systems Immunity for the EU (CE Mark)
LX-SEC-V1000.pdf
